Adjusting The Skew Of The Laser Scanner Unit (Reference) - Kyocera KM-3035 Service Manual

2FD/2FF/2FG

(4) Adjusting the skew of the laser scanner unit (reference)

Perform the following adjustment if the leading and trailing edges of the copy image are laterally skewed (lateral
squareness not obtained).
Caution:
• After adjusting the skew of the laser scanner unit, make a test copy and check the copy image. If lateral squareness is
still not obtained, perform "(6) Adjusting the position of the ISU" (see page 1-6-25).
Procedure
Enter maintenance mode.
Enter "993" using the numeric keys.
Press the start key.
Select "PG2".
Press the interrupt key.
Press the start key and make
a copy at 100% magnification.
Is the image correct?
Press the stop/clear key to
exit maintenance mode.
1-6-22
Start
No
Yes
End
Correct image
Refit the laser scanner unit and
turn the main switch on.
Turn the main switch off and carry out steps
1 to 6 of "(3) Detaching and refitting the laser
scanner unit" (see page 1-6-20).
* In case of copy sample 1
Loosen the screw in the direction of the
white arrow (e).
Reduce the height of the LSU spacer in the
direction of the white arrow (e).
* In case of copy sample 2
Tighten the screw in the direction of the
black arrow (\).
Increase the height of the LSU spacer in
the direction of the black arrow (\)
(See figure 1-6-45).
Screw
Copy Copy
example 1 example 2
Figure 1-6-44
LSU spacer
Figure 1-6-45