Kyocera KM-3035 Service Manual page 304

(4) Other electrical components
12
10
14 15
9
4
5
1. Upper paper feed clutch (PFCL-U) .............. Primary paper feed from the upper drawer.
2. Lower paper feed clutch (PFCL-L) ............... Primary paper feed from the lower drawer.
3. Feed clutch 1 (FCL1) ................................... Controls the drive of feed roller.
4. Feed clutch 2 (FCL2) ................................... Controls the drive of feed roller.
5. Feed clutch 3 (FCL3) ................................... Controls the drive of feed roller.
6. Bypass paper feed clutch (BYPPFCL) ......... Primary paper feed from the bypass tray.
7. Bypass feed clutch (BYPFCL) ..................... Controls the drive of bypass feed roller.
8. Registration clutch (RCL) ............................. Secondary paper feed.
9. Duplex paper feed clutch
(DUPFCL) .................................................... Controls the drive of the duplex feed roller.
10. Feedshift solenoid (FSSOL) ........................ Operates the feedshift guide.
11. Toner feed solenoid (TNFSOL) .................... Replenishes toner.
12. Exposure lamp (EL) ..................................... Exposes originals.
13. Cleaning lamp (CL) ...................................... Removes residual charge from the drum surface.
14. Fixing heater M (FH-M) ................................ Heats the heat roller.
15. Fixing heater S (FH-S) ................................. Heats the heat roller.
16. Fixing unit thermostat (FTS) ........................ Prevents overheating in the fixing section.
16
11
13
8
3
1
2
Figure 2-2-4 Other electrical components
7
6
2FD/2FF/2FG
Machine front
Machine inside
Machine rear
2-2-5