Adjusting The Margins For Printing - Kyocera KM-3035 Service Manual

(3-4) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-31)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the items to be adjusted.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" ¥ 17" paper.
Are the margins correct?
Yes
Proceed to
another mode?
Press the stop/clear key to
exit maintenance mode.
U404
(P. 1-4-63)
Start
LEAD
A
C
TRAIL
TRAIL (DUP) : printer trailing edge margin for
No
Yes
Setting range (initial setting)
No
End
Printer
left margin
(6 ± 2.0 mm)
: printer leading edge margin
: printer left margin
: printer right margin
: printer trailing edge margin
duplex copying (second face)
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the cursor up
key makes the margin winder.
Decreasing the value using the cursor
down key makes the margin narrower.
Printer leading edge margin: 0 – +10 (3.0)
Printer left margin: –3.4 – +10 (2.8)
Printer right margin: –5 – +10 (3.2)
Printer trailing edge margin: –5 – +10 (4.4)
Printer trailing edge margin for duplex copying
(second face): –5 – +10 (4.4)
Changing the value by 1 moves the center line by 0.1 mm.
Printer leading edge margin
(6 ± 2.5 mm)
Printer
right margin
(6 ± 2.0 mm)
Printer trailing edge margin
(6 ± 2.5 mm)
Normal copy mode
(A3/11" × 17")
Figure 1-6-24
Ejection direction
(reference)
Printer trailing edge margin
for duplex copying
Duplex copy mode
(second face, A3/11" × 17")
2FD/2FF/2FG
(6 ± 2.5 mm)
1-6-13