Kyocera KM-3035 Service Manual page 86

Adjusting the height of the finisher
1. Remove the front and rear covers from the
finisher by removing two screws each.
*When removing the covers, open both ends
of the covers in the directions indicated by
the arrows and remove three inside ribs to
remove the covers.
2. Loosen the two screws on the rear right caster of the finisher. Adjust the height of the rear right caster by turning its
adjustment bolt using a cross-headed screwdriver so that the axis of the pin of the latch catch is aligned with the
marking of the slot of the finisher when the finisher is joined to the copier (viewed from the machine front).
Note: Turning the adjustment bolt clockwise lifts the finisher, while turning it counterclockwise lowers the finisher.
3. Adjust the height of the front right caster in the same manner as in step 2 so that each center of the hooking portions
of the latch catch is aligned with the center of the two hooks on the finisher when the finisher is joined to the copier
(viewed from above).
Screws
Hook
Hook
Cover
Screw
Screw
Adjustment bolt
Figure 1-3-146
Hooking
portions
Hooking
portions
Figure 1-3-147
Screw
Cover
Figure 1-3-145
Slot
Pin
2FD/2FF/2FG
Screw
1-3-61