Setting Backup Data Reading/Writing - Kyocera KM-3035 Service Manual

Maintenance
item No.
U917

Setting backup data reading/writing

Description
Stores backup data from the fax control PCB (when an optional fax kit is installed) into CompactFlash or reads
the data from CompactFlash.
Purpose
To store and write data when replacing the PCB.
Setting
1. Turn the power switch off and disconnect the power plug.
2. Remove the middle right cover.
3. Insert Compact Flash in a notch hole of the copier.
4. While pressing the Copier key, turn on the power switch and connect the power plug.
Press and hold on the Copier key until the message "Please wait." disappears.
5. Enter the maintenance item.
6. Press the start key. The screen for selecting an item is displayed.
7. Select the item. The selected item is displayed in reverse.
Display
SRAM→CF:FAX DATA
CF→SRAM:FAX DATA
SRAM→CF:FAX DIAL
CF→SRAM:FAX DIAL
8. Press the start key. Reading or writing is executed, and the screen displays the result.
• If the operation was successful:
EXECUTE 0100
CODE 0000
• If the operation failed:
EXECUTE 0100
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U917 and U926" below.
9. Turn the power switch off and disconnect the power plug.
10. Remove the Compact Flash from the copier.
Error Codes for Operation U917 and U926
Code
0102
0104
0105
01FF
0202
0203
0204
0205
0206
0207
0212
Description
Writing the backup data of fax control PCB
Reading the backup data of fax control PCB
Writing the backup data of fax dial information
Reading the backup data of fax dial information
Detects call for service on fax control PCB.
Communication error.
Detects call for service on main PCB.
CF error.
No CF card.
No data in CF card.
CF data is incompatible.
Bad CF data (Checksum error)
CF read error.
CF write error.
Fax control PCB flash memory error.
Description
Meaning
2FD/2FF/2FG
1-4-69