Kyocera KM-3035 Service Manual page 243

2FD/2FF/2FG
(3-5) Adjusting the amount of slack in the paper
Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Start
Enter maintenance mode.
Enter "051" using the numeric keys.
Press the start key.
Select "RESIST DATA" or
"FEED DATA".
Select the item to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the stop/clear key to
exit maintenance mode.
End
1-6-14
• Amount of slack in the paper at the registration roller
• Amount of slack in the paper at the paper feed roller
Yes
No
Yes
Decrease the value using the cursor down key.
No
Original
DECK DATA : Drawers
BYPASS DATA : Bypass tray
DUPLEX DATA : Duplex copying (second face)
BYPASS : Bypass tray
1ST DECK : Upper drawer
2ND DECK : Lower drawer
3RD DECK : Optional drawer 1
4TH DECK : Optional drawer 2
LCF : Optional large paper deck
Press the start key.
The new setting is stored.
Increase the value using the cursor up key.
Setting range (initial setting)
• Amount of slack in the paper at the registration roller
DECK DATA : –30 – +20 (0)
BYPASS DATA : –30 – +20 (0)
DUPLEX DATA : –30 – +20 (0)
• Amount of slack in the paper at the paper feed roller
BYPASS : 0 – +255 (0)
1ST DECK : 0 – +255 (20)
2ND DECK : 0 – +255 (0)
3RD DECK : 0 – +255 (0)
4TH DECK : 0 – +255 (0)
LCF : 0 – +255 (0)
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
Copy Copy
example 1 example 2
Figure 1-6-25