Upgrading The Printer Board Firmware - Kyocera KM-3035 Service Manual

1-7-4 Upgrading the printer board firmware

Follow the procedure below to upgrade the firmware on the optional printer board.
Firmware upgrading requires the following tools:
Compact Flash (Products manufactured by SANDISK are recommended.)
NOTE
When writing data to a new Compact Flash from a computer, be sure to format it in advance.
Procedure
1. Turn the power switch off and disconnect the
power plug.
2. Insert Compact Flash which has firmware in
to the printer board.
3. Insert the power plug and turn the power
switch on. Upgrading firmware starts.
4. When upgrading the firmware is completed
correctly, the display in Figure 1-7-3 will be
shown on the operation panel screen.
5. Turn the power switch off at the operation
panel screen which shown on Figure 1-7-3
and disconnect the power plug.
6. Remove Compact Flash from the printer
board.
Caution:
If pressing the "Reset" button shown on
Figure 1-7-3, upgrading the firmware will start
again and if turn the power switch off before
the download is finished, writing for the
program will not finish till the end and
[Checksum error F010] will occur.
download end
[∗ ∗ ∗ ∗]
Reset
Figure 1-7-3
2FD/2FF/2FG
1-7-3