U035 Setting Folio Size; Length/Width; U038 Checking The Copier Cover Switch; U051 Adjusting The Amount Of Slack In The Paper - Kyocera KM-3035 Service Manual

Maintenance
item No.
U035 Setting folio size
Description
Changes the image area for copying onto folio size paper.
Purpose
To prevent the image at the trailing edge, or right or left side of the paper from not being copied b y setting the
actual size of the folio paper used.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select the item to be set. The selected item is displayed in reverse.
2. Change the setting using the cursor up/down keys.
Display
LENGTH DA TA
WIDTH DA TA
3. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No . is displayed.
U038 Checking the copier cover switch
Description
Displays the on-off status of each cover switch.
Purpose
To check if the switches of covers operate correctly.
Method
1. Press the start key. A list of the switches, the on-off status of which can be chec ked, are displayed.
2. Open and close each cover to check the status of each switch.
When the cover is closed, the switch shall be displayed in reverse. When the cover is open, the switch shall
be displayed normally.
Display
INTER LOCK SW
FRONT COVER
LEFT1 COVER
LEFT2 COVER
Completion
Press the stop/clear key. The screen for selecting a maintenance item No . is displayed.
U051 Adjusting the amount of slack in the paper
Adjustment
See page 1-6-14.
Description
Setting
Length
Width
Switches
Safety switch 1 and 2 (SSW1 and 2)
Front cover switch (FRCSW)
Conveying cover switch (CCSW)
Side cover switch (SCSW)
Setting range
330 to 356 mm
200 to 220 mm
2FD/2FF/2FG
Initial setting
330
210
1-4-21