Kyocera KM-3035 Service Manual page 248

7. Loop the outer ends of the scanner wires around the grooves in the scanner wire pulleys at the left of the
scanner unit, winding from below to above. .................................................................................................... 4
8. Loop the scanner wires around the outer grooves in the pulleys on the mirror 2 frame, winding from below to
above. ............................................................................................................................................................. 5
9. Wind the scanner wires around the grooves in the scanner wire guides at the left of the scanner unit. ........ 6
10. Hook the round terminals onto the scanner tension springs. .......................................................................... 7
11. Remove the scanner wire stoppers and frame
securing tools.
12. Gather the scanner wires toward the locating
balls.
13. Move the mirror 2 frame from side to side to
correctly locate the wires in position.
14. Put the mirror 1 frame on the scanner rail and
move it toward the left side of the machine.
15. Insert the frame securing tools into the
positioning holes (leftmost holes) at the front
and the rear of the scanner unit and screw
the mirror 1 frame while securing both the
mirror 1 frame and the mirror 2 frame.
16. Remove the two frame securing tools
17. Refit all the removed parts.
Figure 1-6-36
Frame securing tools
Mirror 1 frame
Figure 1-6-37
2FD/2FF/2FG
1-6-19