Removing The Bypass Forwarding Pulley - Kyocera KM-3035 Service Manual

8. Raise the bypass paper feed shaft as shown
in the illustration, remove the stop ring, and
then remove the bypass paper feed pulley.
Caution:
• When fitting the bypass paper feed pulley, keep
the blue end of the paper feed toward the
machine rear.

• Removing the bypass forwarding pulley

9. Remove the wire of the bypass paper feed
clutch from the clamp.
10. Remove the stop ring and bypass paper feed
clutch.
• When refitting, insert the cutout in the
bypass paper feed clutch over the stopper
on the copier.
11. Remove the screw from the cam at the rear
of the bypass forwarding pulley shaft and
move the cam and the bushing toward the
inner side.
Stop ring
Bypass paper feed pulley
Figure 1-6-13
Stop ring
Clamp
Bypass paper feed clutch
Figure 1-6-14
Bushing
Bypass forwarding pulley shaft
Cam
Figure 1-6-15
2FD/2FF/2FG
Bypass paper feed shaft
1-6-7