2FD/2FF/2FG
9. Pull the finisher away, and tighten up the two
M4 × 10 TP-A bronze screws.
10. Set the finisher against the copier.
11. Open the finisher's front cover.
12. Remove the tape securing the internal tray
unit.
13. Remove the fastening pin holding the internal
tray unit in place, and pull out the middle tray
unit.
1-3-66
M4 × 10
TP-A bronze screws
Figure 1-3-159
Internal tray
unit
Front cover
Figure 1-3-160
Fastening pin
Internal tray
unit
Figure 1-3-161
Tape