Item No; Maintenance Item Contents; Initial Setting - Kyocera KM-3035 Service Manual

Item
Section
No.
U093 Setting the exposure density gradient
Optical
U099 Initializing original size
U100 Checking the operation of main high voltage
High voltage
U101 Setting high voltages
U109 Displaying the drum type
U110 Checking/clearing the drum count
U112 Setting toner refresh operation
U113 Performing the drum refreshment
U114 Setting separation charger mode
U117 Checking the drum number
U118 Displaying the drum history
U130 Initial setting for the developer
Developing
U144 Setting toner loading operation
U150 Checking sensors and switches for toner
U157 Checking/clearing the developing drive time
U158 Checking the developing count
U161 Setting the fixing control temperature
Fixing and
cleaning
U162 Stabilizing fixing forcibly
U163 Resetting the fixing problem data
U165 Checking fixing counts
U196 Turning the fixing heater on
U198 Setting the fixing phase control
U199 Checking the fixing temperature
* Initial setting for executing maintenance item U020

Maintenance item contents

• Text and photo/text/photo/text in fax mode/photo in fax mode
• Developing bias AC component frequency at image f o rmation
• Developing bias AC component duty at image f o rmation
• Developing shift bias potential at image formation
• Transfer control voltage
• Time of toner refreshment
• Developing bias on time
• Specifying SC Whole mode to ON/OFF
• Specifying the temperature/humidity of which SC Whole mode in ON
• Specifying SC Whole mode to ON/OFF when using thin paper
• Specifying SC Whole mode to ON/OFF when using plain paper
• Control temperature during copying
• Primary stabilization fixing temperature
• Secondary stabilization fixing temperature
• Time from power on to stabilization of fixing
• Fixing temperature decrease amount f o r duplex copying
• Fixing temperature decrease amount f o r duplex copying for copy store
section/optional mail box ejection
• Fixing correct temperature for large size copying
• Fixing correct temperature for middle size copying
• Fixing correct temperature for small size copying
• Fixing temperature increase amount at low temperature and low humidity
• Fixing temperature decrease amount at high temperature and high humidity
• Variable range of correct temperature for fixing heater M
2FD/2FF/2FG-3.0
Initial
setting*
0/0/0/2/3
—
—
0
0
0
120
—
—
120
700 (30 cpm)
540 (40/50 cpm)
—
ON
20/50
OFF
MODE0
—
—
—
MODE2
—
—
—
130
115 (30 cpm)
120 (40/50 cpm)
130 (30 cpm)
145 (40/50 cpm)
0
5
0
45 (30 cpm)
50 (40 cpm)
65 (50 cpm)
45 (30 cpm)
60 (40 cpm)
70 (50 cpm)
25 (30 cpm)
40 (40 cpm)
45 (50 cpm)
5
0
0
—
—
—
—
OFF
—
1-4-11