Kyocera KM-3035 Service Manual page 247

2FD/2FF/2FG
3. Insert the two frame securing tools into the
positioning holes at the front and rear of the
scanner unit to pin the mirror 2 frame in
position.
4. Loop the inner ends of the scanner wires around the grooves in the pulleys at the right of the scanner unit,
winding from below to above. ......................................................................................................................... 1
5. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from above to
below. .............................................................................................................................................................. 2
6. Hook the round terminals onto the catches inside the scanner unit. .............................................................. 3
1-6-18
Frame securing tools
Figure 1-6-35
Mirror 2 frame
Figure 1-6-34