Kyocera KM-3035 Service Manual page 90

4. Remove the tape securing the solenoid, and
the tape securing the shifting guide.
5. Set the waste punch box back into the
finisher, and fasten it into place with the two
fastening pins.
6. Pull the rail unit out of the finisher.
7. Loosely fasten the rail unit to the copier's
finisher-attachment area with the two M4 × 10
TP-A bronze screws.
8. Move the finisher next to the copier, and open the finisher's front cover. Adjust the height-adjustment screw in the rail
unit until the guideline marked on the retainer is aligned with the center of the height-adjustment plate.
Height-adjustment
plate
M4 × 10
TP-A bronze screws
Guideline
Figure 1-3-158
Solenoid
Shifting guide
Figure 1-3-156
Figure 1-3-157
Height-adjustment
screw
Rail unit
2FD/2FF/2FG
Tape
Tape
Rail unit
1-3-65