2FD/2FF/2FG
5. Remove the screw and then the cover from
the rear of the paper feeder.
6. Remove the screw from the copier.
7. Insert the 12-P connector of the paper
feed desk into the connector on the copier.
8. Route the harness through the clamp on the
retainer.
Check that the harness and the motor do not
contact.
9. Fit the retainer using the screw removed in
step 6 and the two CVM4 × 06 cross-head
chromate binding screws.
10. Refit the cover.
1-3-14
Screw
Screw
Figure 1-3-21
12-P connector
Figure 1-3-22
Harness
Motor
Figure 1-3-23
Cover
Retainer
Screw
Clamp
CVM4 × 06 cross-head
chromate binding screws