Selecting A Site - NEC Express5800 series User Manual

3-4 Setting Up Your Server

SELECTING A SITE

To use the server, install it on a standard EIA 19-inch rack assembly.
Refer to the documentation attached to the rack or contact your service representative for the
installation of the server on the rack.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-2
to 1-6 for details.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-2 to 1-6 for details.
Do not use the server in any unapproved place.
Do not connect the ground wire to a gas pipe.
Do not carry or install the server by yourself.
Do not install the server where the load will be concentrated on a specific
point.
Do not install any component on the server by yourself.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device pulled out from the rack at the same
time.
Do not provide the wiring exceeding the rating power.
WARNING
CAUTION