NEC Express5800 series User Manual page 185

Cannot install the operating system correctly.
Did you check the notes on installing the operating system?
→ See Chapter 5.
Fail to start the OS:
Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the server.
Is the BIOS configuration correct?
→ Run the BIOS SETUP utility to change the boot order (see Chapter 4).
Is the OS crashed?
→ Use recovery process to recover the system. (See "Recovery for Windows 2000
System" in this Chapter.)
The event log after every logon to Windows 2000 includes the following error log:
Description (D)
The CPUs in this multiprocessor system are not all the same revision level.
To use all processors the operating system restricts itself to the features of
the least capable processor in the system. Should problems occur with
this system, contact the CPU manufacture to see if this mix of processors
is supported.
Has the CPU been expanded?
→ If different revisions (stepping) of processors are installed in the multiprocessor
system, Windows 2000 logs the above information at every startup. If this
message is logged, it is not a problem for operation.
The OS presents unstable operation <Windows 2000>:
Did you update the system?
→ Installing a network drive after installation of the OS may cause unstable
operation. Use the NEC EXPRESSBUILDER CD-ROM to update the system.
(See Chapter 5.)
When any trouble occurred, the system does not run according to the specification of
"Restart automatically" <Windows 2000>:
→ When any trouble occurred on Windows 2000, the system may not restart
automatically even if "Restart automatically" is specified. In such case, restart the
system manually.
Troubleshooting 8-13