Recovery For Windows System - NEC Express5800 series User Manual

8-20 Troubleshooting

RECOVERY FOR WINDOWS SYSTEM

If any file necessary used for running the OS is damaged, use the following procedures to recover
the system.
IMPORTANT:
After recovering the system, see "Updating the System" in Chapter
5 and be sure to update the system.
Also on Windows 2000, you need to update all the drivers after the
system update. For more information, see "Installing and Setting
Device Drivers" in Chapter 5.
Concerning Windows 2000, see "Installing and Setting Device
Drivers" and "Updating the System" in Chapter 5 and be sure to
update both the drivers and the system.
If the hard disk drive can not be recognized, you can not recover the
system.
For Windows Server 2003
If the system fails to start for some reason, rebuild the system using the recovery console. Note that
this method is recommended for only users and administrators who have a thorough knowledge of
the recovery console.
For more information, refer to Online Help.
For Windows 2000
Follow the procedure below and use the information in the disk, not the system recovery disk, to
recover the system.
1.
Insert the Windows 2000 CD- ROM into the CD-ROM drive.
2.
Power on the system.
3.
Press F6 while the message "Setup is inspecting your computer's hardware
configuration..." is displayed at the upper part of the screen.
NOTE: Nothing changes on the screen though F6 is pressed.
<If the USB CD-ROM drive is not connected with your system>
Proceed to step 8 according to the on-screen instructions.