NEC Express5800 series User Manual page 72

4-6 Configuring Your Server
Security
To set passwords on the BIOS level
Select [Security] - [Set Supervisor Password] and enter a password.
Set Supervisor password first, then User password.
To enable/disable the POWER switch (a supervisor password must be set first)
Select [Security] - [Power Switch Inhibit] - [Unmasked].
Select [Security] - [Power Switch Inhibit] - [Masked].
IMPORTANT:
shutdown (see Chapter 8) as well as power on/off using the POWER
switch.
External Devices
To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Advanced] - [Reset Configuration Data] - [Yes].
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] → [Exit Saving Changes] or [Save Changes].
To discard changes to the BIOS configuration data
Select [Exit] → [Exit Discarding Changes] or [Discarding Changes].
To resume the default BIOS configuration data (may differ from factory-set value)
Select [Exit] → [Load Setup Default].
To save the current settings as user-defined configuration
Select [Exit] - [Save Custom Defaults].
To load the user-defined configuration data
Select [Exit] - [Load Custom Defaults].
Masking the POWER switch disables forced