NEC Express5800 series User Manual page 180

8-8 Troubleshooting
On-screen error message
0BD1 1st SMBus device Error detected.
0BD2 1st SMBus timeout.
0BD3 2nd SMBus device address not
acknowledged.
0BD4 2nd SMBus device Error detected.
0BD5 2nd SMBus timeout.
0BD9 4th SMBus device address not
acknowledged.
0BDA 4th SMBus device Error detected.
0BDB 4th SMBus timeout.
0BDC 5th SMBus device address not
acknowledged.
0BDD 5th SMBus device Error detected.
0BDE 5th SMBus timeout.
0BE8 IPMB device address not acknowledged.
0BE9 IPMB device Error detected.
0BEA IPMB timeout.
8100 Memory decreased in Size
Expansion Rom not initialize
Invalid System Configuration Data
Resource Conflict
System Configuration Data Read error
System Configuration Data Write error
WARNING: IRQ not configured
IMPORTANT:
displayed due to insufficient expansion ROM area. Select one of the
features of the lowest frequency and set it to "Disabled".
– Legacy USB Support
– On board LAN 1/On board LAN 2
– PCI slot 1
Action
Power off and reboot the server. If the error
persists, contact your service representative.
Contact your service representative.
Run the BIOS SETUP utility to disable the use
of expansion ROM area and PCI slot
OptionROM. If the error persists, contact your
service representative.
Contact your service representative.
The message "Expansion Rom not initialized" may be