NEC Express5800 series User Manual page 132

5-22 Installing the Operating System
Setting Up the Device Driver (Normally Installed in Server)
For the installation and setup of each optional device driver, refer to the documentation shipped with
the option.
Network Driver
Two network drivers for the standard equipment are automatically installed.
However, the transfer rate and duplex mode of each network driver must be set.
Using Windows Server 2003
[If PROSet is not installed]
1.
The [Local Area Connection Properties] dialog box appears.
* If using a standard start menu
1. Click the Start menu, Click [Control Panel], Click [Network Connections], and Click
[Local Area Connection].
* If using a classic start menu
1. Click the Start menu, Click [Settings] and Click [Network Connections].
The [Network Connections] dialog box appears.
2. Right-click [Local Area Connection] and click [Properties] from pop-up menu.
2.
Click [Configure].
The property dialog box for network adapter appears.
3.
Click the [Advanced] and specify the [Link Speed & Duplex] value the same as the value
specified for HUB.
4.
Click [OK] on the property dialog box for network adapter.
[If PROSet is installed]
1.
The [Intel(R) PROSet for Wired Connections] dialog box dialog box appears.
* If using a standard start menu
Click the Start menu, point to [Control Panel] and click [Intel(R) PROSet Wired].
* If using a classic start menu
1. Click the Start menu, point to [Settings] and click [Control Panel].
2. Double-click [Intel(R) PROSet Wired] on the [Control Panel] window.
2.
Click [Intel(R) PRO/1000 MT Dual Port Network Connection] in the list.
3.
Click the [Speed] and specify the [Link Speed & Duplex Settings] value the same as the
value specified for HUB.
4.
Click [Apply] and click [OK].