NEC Express5800 series User Manual page 83

IMPORTANT:
User password setup is not available before a Supervisor password
is setup.
Do not set any password before installing the OS.
If you have forgotten your password, ask your service
representative.
Available options in the Security menu are listed below.
Option Parameter
Set User Up to 7
Password alphanumeric
characters
Set Supervisor Up to 7
Password alphanumeric
characters
Password on [Disabled]
boot
Enabled
Secure Mode [Disabled]
Timer
1 min
2 min
5 min
10 min
30 min
1 hr
2 hr
Hot Key [L]
(CTRL+ALT+)
Z
Secure Mode [Disabled]
Boot
Enabled
Power Switch [Unmasked]
Inhibit
Masked
Description
Press Enter to display the user password
entry screen. With a user password,
accessible SETUP menus are restricted.
This option is available only if the
Supervisor Password is specified.
Press Enter to display the supervisor
password entry screen. With the
supervisor password, all SETUP menus
are available for access. This option is
available only when you log into the
SETUP utility with the supervisor
password.
Specify whether to request a password
entry at boot-up. Supervisor password
setup is required beforehand. When the
supervisor password is specified and this
option is disabled, the BIOS assumes that
a system boot attempt is made by a user.
Note: a supervisor password must be set
first.
Specify the period from no input from the
keyboard or mouse to the point at which
the system enters into the secure mode.
If this item is set to [Disabled], the secure
mode is unavailable.
Note: a supervisor password must be set
first.
Specify the key with which the secure
mode is started. Press the selected key
with the Ctrl and Alt pressed to start the
secure mode.
Note: a supervisor password must be set
first.
Specify whether the server starts in the
secure mode or not.
Note: a supervisor password must be set
first.
Enable or disable the POWER switch of
the server. If "Masked" is selected,
power-off with the POWER switch
Configuring Your Server 4-17
Your Setting