NEC Express5800 series User Manual page 141

Settings for Solving Problems
Setup the following utilities in advance so that your computer can recover from any trouble
precisely and as soon as possible when it should occur.
Memory Dump (Debug Information) - Windows Server 2003 -
This section describes the procedures for collecting the memory dump (debug information) in the
server.
IMPORTANT: Cautions for the Memory Dump
The maintenance service staff is in charge of collecting memory
dump. You only need to specify the memory dump.
If any trouble occurs after specifying the process below, a message
warning that the system is lacking virtual memory may appear, but
we recommend you continue to start the system. If you re-start the
system in such case, the memory dump may not be stored
correctly.
Follow the procedure below to set up the memory dump.
1.
Select [Control Panel] and click [System].
The [System Properties] dialog box appears.
2.
Select the [Advanced] tab.
3.
Click [Settings] on the [Startup and Recovery] group box.
IMPORTANT:
We recommend you specify "Complete Memory Dump" to write
the debug information.
If the mounted memory size is larger than 2GB, "Complete
Memory Dump" cannot be specified so you need to specify
"Kernel Memory Dump" instead.
Specify a drive where there is a free area larger than the size of the
memory capacity mounted on Express server + 12MB.
If the mounted memory size exceeds 2GB because you added
memory, change the write debugging information to [Kernel
Memory Dump]. If you add memory, do not forget to change the
size of the memory dump. Check how much space remains to the
write destination drive.
Installing the Operating System 5-31