Function Select: Utility: Factory Set-Up - Comtech EF Data SNM-1001L Installation And Operation Manual

SNM-1001L Satellite Modem
Front Panel Operation
FUNCTION SELECT: MODEM TYPE:
CONFIGURATION CODE – CARD #3 (CONDITIONAL)
Comtech EF Data-supplied code. Press <ENTER>
IMPORTANT
On entry, the current configuration code is displayed with the flashing cursor on the first
character. Press [
the digit at the flashing cursor. Press <ENTER> to execute the change.
Entering this code enables the corresponding modem option. To purchase an option, contact an
Comtech EF Data marketing representative for more information.
4.3.6.8

FUNCTION SELECT: UTILITY: FACTORY SET-UP

CAUTION
CONFIGURATION
CODE – CARD #3
This menu appears only if the Overhead card is installed.
1)AAAAAAAAAA
2)AAAAAAAAAA
] or [ ] to move the flashing cursor. Press [
← →
UTILITY
FACTORY SET-UP
This configuration is used for factory alignment. Unauthorized persons
should not change factory setup. Doing so can cause modem failure.
4–94
Revision 1
MN/SNM1001L.IOM
] or [ ] to increment or decrement
↑ ↓