Function Select: Monitor: Lnb Current; Function Select: Monitor: Lnb Voltage - Comtech EF Data SNM-1001L Installation And Operation Manual

SNM-1001L Satellite Modem
Front Panel Operation
IMPORTANT
Displays the current framing pattern bit error rate or "No Data" (if carrier is not locked). Monitors
the currently selected READ_ERROR function.
Range: < mm.m E-e to > mm.m E-e.
Notes:
1.
2.
Frame Errors
2047 Errors

FUNCTION SELECT: MONITOR: LNB CURRENT

Monitors the LNB current or "LNB POWER OFF."
Current displayed is 0 to 500 mA in 1 mA increments.

FUNCTION SELECT: MONITOR: LNB VOLTAGE

Monitors the LNB voltage or "LNB VOLTAGE OFF."
Voltage displayed is 0 to 24 VDC, in 1volt increments.
Conditional: This menu available only when the optional Overhead
Card is installed.
Low limit is based on performance.
High limit is based on the data/code rate.
Measured when framed modes of operation are active.
Measured when the RX 2047 PATTERN (under the Configuration: Interface menu)
is tuned On.
LNB CURRENT
XXX mA
LNB VOLTAGE
XX VOLTS
4–41
Revision 1
MN/SNM1001L.IOM