Comtech EF Data SNM-1001L Installation And Operation Manual page 292

SNM-1001L Satellite Modem
Remote Control Operation
Interface Command:
Config. Response:
Status
<add/ICS_'cr'
>add/ICS_'cr'
TC_xxxx'cr'
ERF_nnnnn.n'cr'
TCP_xxxx'cr'
RCP_xxxx'cr'
BBL_xxx'cr'
ILB_xxx'cr'
ILT_xxx'cr'
ICFT_xxxx'cr'
ICFR_xxxx'cr'
BC_xxx'cr'
IRFS_T1_ssss'cr'
IRFS_E1_ssss'cr'
IBP_xxx'cr'
IBS _nnnnnn'cr'
ITOT_xxxxx'cr'
IROT_xxxxx'cr'
ISP_xxxxxx'cr'
IRE_xxxxxx'cr'
TDF_xxxx'cr'
RDF_xxxx'cr
ISCL_TX1_nnn'cr'
ISCL_TX2_nnn'cr'
ISCL_RX1_nnn'cr'
ISCL_RX2_nnn'cr'
TDP_xxxx'cr'
RDP_xxxx'cr'
DDF_xxxxxx'cr' (Note 1)
BDCA_dd;cc_dd;cc...'cr' (Note 1)
ICRC_xxx'cr' (Note 2)
IDF_xxxxxx'cr' (Note 2)
BICA_dd;cc_dd;cc...'cr' (Note 2)
BW_TX1_nnn'cr' (Note 3)
BW_TX2_nnn'cr' (Note 3)
BW_TX3_nnn'cr' (Note 3)
BW_TX4_nnn'cr' (Note 3)
BW_RX1_nnn'cr' (Note 4)
BW_RX2_nnn'cr' (Note 4)
BW_RX3_nnn'cr' (Note 4)
BW_RX4_nnn'cr' (Note 4)
TXDR_xxxxxx'cr'
RXDR_xxxxxx'cr'
TOBR_nnnnn'cr' (Note 5)
TCCL_n'cr' (Note 5)
TCSB_n'cr' (Note 5)
TOCP_xxxx'cr' (Note 5)
TCT_xxxxx'cr' (Note 5)
ROBR_nnnnn'cr' (Note 6)
RCCL_n'cr' (Note 6)
RCSB_n'cr' (Note 6)
ROCP_xxxx'cr' (Note 6)
RCT_xxxxx'cr' (Note 6)
LPC_xxx'cr' (Note 5)
NOMP_snn.n'cr' (Note 5)
MINP_snn.n'cr' (Note 5)
MAXP_snn.n'cr' (Note 5)
LCL_xxxx'cr' (Note 5)
RCL_xxxx'cr' (Note 5)
ENSP_nn.n'cr' (Note 6)
MAXT_n.n'cr' (Note 6)
RTSM_xxx'cr'
TSD_xx'cr'
IDRT_xxxxx'cr' (Note 3)
IDRR_xxxxx'cr' (Note 4)
IBST_xxxxx'cr' (Note 3)
IBSR_xxxxx'cr' (Note 4)
Transmit Clock (Source)
External Reference Frequency
Transmit Clock Phase
Receive Clock Phase
Baseband Loopback
Interface Loopback
Interface Loop Timing
Interface Coding Format Transmit
Interface Coding Format Receive
Buffer Clock (Source)
Interface Receive Frame Structure (T1)
Interface Receive Frame Structure (E1)
Interface Buffer Programming
Interface Buffer Size
Interface Transmit Overhead Type
Interface Receive Overhead Type
Interface Substitution Pattern (TX 2047)
Interface Read Error (RX 2047)
Transmit Data Fault
Receive Data Fault
Service Channel Level TX1
Service Channel Level TX2
Service Channel Level RX1
Service Channel Level RX2
Transmit Data Phase
Receive Data Phase
Drop Data Format
Bulk Drop Channels Assignment
Insert E1 CRC Enable
Insert Data Format
Bulk Insert Channels Assignment
Backward Alarm Enable TX1
Backward Alarm Enable TX2
Backward Alarm Enable TX3
Backward Alarm Enable TX4
Backward Alarm Enable RX1
Backward Alarm Enable RX2
Backward Alarm Enable RX3
Backward Alarm Enable RX4
TX Driver Type
RX Driver Type
ASYNC Transmit Overhead Baud Rate
ASYNC Transmit Channel Character Length
ASYNC Transmit Channel Stop Bits
ASYNC Transmit Overhead Channel Parity
ASYNC Transmit Communications Type
ASYNC Receive Overhead Baud Rate
ASYNC Receive Channel Character Length
ASYNC Receive Channel Stop Bits
ASYNC Receive Overhead Channel Parity
ASYNC Receive Communications Type
AUPC Local Power Enable
AUPC Nominal Power Value
AUPC Minimum Power Value
AUPC Maximum Power Value
AUPC Local Carrier Loss
AUPC Remote Carrier Loss
AUPC EBN0 Target Set Point
AUPC Max. Tracking Rate
RTS TX-IF Control Mode
CTS Delay Time
IDR Transmit ESC Type
IDR Receive ESC Type
IBS Transmit ESC Type
IBS Receive ESC Type
B–18
Revision 1
MN/SNM1001L.IOM