Comtech EF Data SNM-1001L Installation And Operation Manual page 314

SNM-1001L Satellite Modem
Remote Control Operation
Serial Command:
Number Response:
State Of Command:
Product Response:
<add/SNUM_'cr'
>add/SNUM_'cr'
MODEM_xxxxxxxxx'cr'
CARD_1_xxxxxxxxx'cr' (Note 1)
CARD_2_xxxxxxxxx'cr' (Note 2)
CARD_3_xxxxxxxxx'cr''lf'] (Note 3)
<add/SOP_'cr'
>add/SOP_'cr'
add'cr'
abc'cr'
rrrrr bps'cr'
<var-string1>'cr'
<var-string2>'cr''lf']
Where: xxxxxxxxx = Serial number 000000000 to 999999999.
Notes:
1. Data is only returned if Card #1 is installed.
2. Data is only returned if Card #2 is installed.
3. Data is only returned if Card #3 is installed.
Product Address
Data Format
Baud Rate
Comm Type
Where: abc = Explained below.
a = Number of data bits (7).
b = Parity type (O, E, N).
c = Number of stop bits (2).
rrrrr = baud rate ("150", "300", "600", "1200", "2400",
"4800", "9600", "14.4K", "19.2K").
<var-string1> = Variable length strings explaining
communication hardware type "RS-485, 2 wire", "RS-485,
4 wire", "RS-232".
<var_string2> = Variable length strings explaining the
intention of the product. "Under normal system operation",
"REFLASH of BULK firmware required", "REFLASH of
M&C firmware required".
B–40
Revision 1
MN/SNM1001L.IOM