Table of Contents
Advertisement
If
the start-up indicator follows any pattern other than the one described above,
turn the DECmux II main power off, wait 20 seconds, and reapply the main
power.
If
the second attempt is not successful, the unit is faulty and will re-
quire service.
6.1.1.2
Data Set Ready Indicators -
The two red LED indicators on the rear
connector panel indicate the status of the composite port DATA SET READY
conductors. The ON state indicates successful connection to a modem on the
respective composite port. The OFF state indicates that the modem is either in
the process of connecting or not connected.
6.1.2 Controls
All DECmux II control functions are executed by means of the supervisor port,
or by means of a CONNECT command through the network from the
MUXserver 100 or second DECmux II unit.
-
A terminal such as the VT220 is required to access the control functions by
means of the supervisor port; however, it is not necessary for the terminal to
remain permanently connected after the DECmux II unit has been set up and
its operational parameters saved in non-volatile memory.
2
CHAPTER 6 DECmux II OPERATION
Advertisement
Table of Contents
