Table of Contents
Advertisement
6.3.10 RESTART Command
The RESTART command resets the multiplexer. It has the same effect as a
power-up initialization, described in Section 6.2.1 (Starting YoUR DECmux II).
Because this command will interrupt normal operation of the network, the oper-
ator is asked to confirm the operation, as shown in the example below.
If
the RESTART command is executed from a CONNECTed remote supervisor
port, the link will be DISCONNECTed automatically first. A RESTART of a
SLAVE MUX only restarts that MUX, not the network.
Syntax:
RESTART
Example:
SYS>RESTART
WARNING - a restart will disrupt network users.
Do you really want to rastart [NO]?Y
Restarting ...
DFMZA - Startup test - Firmware Version Vx.x-xx
6.3.11 SAVE Command
The SAVE command stores all the current asynchronous and synchronous port
and mapping parameters in the non-volatile memory. On system initialization,
the port parameters will be taken from the non-volatile memory. Also, on initia-
lization of the MUXserver 100, the link mapping table will be downloaded and
used to initialize the DECmux II units.
Syntax:
SAVE
The SAVE command should be issued after the following commands, if they
have modified parameters:
COPY, PASSWORD, PORT, SYSTEM, MAP
If
the unit is operating correctly, then the system will issue the response "Save
complete".
18
CHAPTER 6 OECmux II OPERATION
Advertisement
Table of Contents
