Table of Contents
Advertisement
5.31 SHOW PORTS
Use this command to display information about MUXserver 100 ports.
This information includes the characteristics that you assign with the DEFINE
and SET PORT commands. SHOW PORT displays the characteristics that re-
side in both the server's operational and permanent databases. The characteris-
tics in parentheses are the permanent characteristics. They take effect each
time the port user logs in.
Show port commands entered at privileged and non privileged ports differ
slightly.
You can interrupt a show port display with < BREAK>. The local prompt
reappears.
Syntax:
SHOW PORTS [number ][BRIEF]
where
number
ALL
ACCESS
BRIEF
FULL
[ACCESS {DYNAMIC} ][FULL ]
[
{NONE }]
[
{REMOTE }]
[ALL
]
specifies a partieular port for which information is dis-
played. The nUIltber must be in the range 1 to 8.
If
you
enter show port only, the default port is the port you are
using.
states that information for all ports is to be included in
the display.
limits the display to only those ports with ACCESS set
to the value you choose. ACCESS is the ACCESS port
characteristic (see the DEFINE/SET PORT command).
generates a one-line-per-port display for the ports you
specify with nuntlber, ALL, or ACCESS. BRIEF is the de-
fault if you enter ACCESS or ALL.
produces a complete listing of all port characteristics and
some error counters. FULL is the default
if
you specify a
port number or if you enter only SHOW PORT.
CHAPTER 5 MUXsI:trver 100 COMMAND DESCRIPTIONS
51
Advertisement
Table of Contents
