Lat Protocol Errors - Digital Equipment MUXserver 100 Reference Manual

Problem The service node exceeded a timeout limit.
Correction: Attempt to reconnect to the service. This condition usu-
ally means that the service node has crashed, or is otherwise unrea-
chable. You can check its status by entering the SHOW NODES
command with the node name. Report the problem to the system
manager of the service node.
Local -224- Connection to 'name' not established
Circuit timer out of range
Local -264- Connection to 'name' not established
Circuit timer out of range
Problem The server circuit timer value is out of the range specified by the
service node's system manager.
Correction: Determine the correct circuit timer range. Enter the
SET SERVER CIRCUIT TIMER command to reset the timer value
(refer to Chapter 2, Section 2.6, SETTING UP THE NETWORK
MAP). If this solves the problem, enter the new timer value with
DEFINE SERVER CIRCUIT TIMER. This command places the
new value in the permanent database.
4.5.2 LAT Protocol Errors
A service node or the MUXserver 100 detected messages that violate the LAT
protocol. An error message in the following groups may appear:
Local -202- Connection to 'name' not established
Communication protocol error
Local -207- Connection to 'name' terminated
Communication protocol error
CHAPTER 4 MUXserver 100 TROUBLESHOOTING 37