Table of Contents
Advertisement
6.3.8 PASSWORD Command
The PASSWORD command allows the operator to change the password that
protects the supervisor port from unauthorized use.
The password is initially factory-set to "SYSTEM". The password may contain
any sequence of eight printable characters.
The system will prompt for the current password, and then the new password.
It
will then request verification of the new password as shown below.
If
the old
password is not correct, or the two entries do not match, then the password
will
not be changed. Neither the new or old passwords will be echoed. It is
recommended that the password be changed after installation.
Syntax:
PASSWORD
:Example:
SYS>PASSWORD
Old password:SYSTEM
New password:NEWPASS
Ver;fy:NEWPASS
SYS>SAVE
Save complete
SYS>
} Passwords
} are not
) echoed
It
is necessary to enter the SAVE command (see Section 6.3.11) to retain the
new password in non-volatile memory.
14
CHAPTER 6 OECmux II OPERATION
Advertisement
Table of Contents
