Setting Characteristics To Factory Specifications - Digital Equipment MUXserver 100 Reference Manual

2.9 SETTING CHARACTERISTICS TO FACTORY
SPECIFICATIONS
This feature is available on both the MUXserver 100 and the DECmux II units
to allow a complete system reset to factory default values.
2.9.1 Resetting the
MUXserv.~r
100 to Factory Settings
The software reset feature permits you to change the data in the permanent
database to DIGITAL factory specifkations. This feature is useful, for example,
if you forget the passwords you set up with the DEFINE PRIVILEGED
PASSWORD command or the DEFINE LOGIN PASSWORD command.
DIGITAL recommends that software reset be executed only when absolutely
required.
To cause a software reset, locate the RESET button on the back of the
MUXserver 100 hardware unit. Simultaneously press this button while you
switch the power ON/OFF switch on the front of the unit OFF then ON.
An
immediate server initialization occurs; all permanent and operational database
parameters are reset to factory specifications.
NOTE
DIP switches will not change. 'To reset RS-422 back to RS-232, see
Section 2.5.1.1.
Following the reset procedure, the privileged password is "system", and the
login password is "access". To maintain security, you should change these pass-
words (see Section 2.2, SETTING UP THE PRIVILEGED PASSWORD, and
Section 2.3, SETTING UP THE LOGIN PASSWORD).
CHAPTER 2 SETTING UP THE MUXserver 100 AND ITS TERMINALS 37