Monitoring The Muxserver 100 (By Means Of The Network Remote Console Or Supervisor Port Terminal) - Digital Equipment MUXserver 100 Reference Manual

PASSWORD ENABLED
PREFERRED SERVICE NONE
SESSION LIMIT 1
TYPE HARDCOPY
VERIFICATION ENABLED
The characteristics SPEED, CHARACTER SIZE, and PARITY are irrelevant
for the remote console.
Here are other notes about MUXserver 100 commands for the remote console:
• You can enter the CONNECT command to use network services.
However, you can have only one active session (up to six are possible
at the other terminals).
• If
you connect to a service node with the remote console, you should
not activate another remote console session from that node.
• You can use privileged commands if you know the privileged pass-
word for the SET PRIVILEGED command. This includes all commu-
nications commands connecting to a remote DECmux II unit, and so
on.
• Use the fixed local switch character
n
to enter local mode.
Personal computer (PC) file transfers are not supported over the remote
console.
3.2 MONITORING THE MUXserver 100 (By Means of
the Network Remote Console or Supervisor Port
Terminal)
MUXserver 100 SHOW commands enable you to monitor the server, its termi-
nals, and the interaction among the service nodes. This section discusses what
to look for in the SHOW command displays. Chapter 5, MUXserver 100
COMMAND DESCRIPTIONS, describes the command syntax for each com-
mand. Chapter 5 also has examples of the displays and descriptions of the data
fields in the displays.
8 CHAPTER 3 MANAGING AND MONITORING