Lock - Digital Equipment MUXserver 100 Reference Manual

5.13 LOCK
Use this command to disable your port and prohibit access by unauthorized
users.
The LOCK command does not disconnect current service sessions. When you
issue the LOCK command, the server prompts you for a password and a verifi-
cation of the password. The LOCK password is a string of 1 to 6 keyboard
characters.
Upon password verification, the server prints a short informational message
and prompts you to re-enter the password to unlock the port. The port cannot
be used until you enter the correct password. When you type the correct pass-
word, the port is unlocked and the Local> prompt returns.
If
you type an in-
correct password, the password prompt is reissued.
Syntax:
where
LOCK
Lock password>
Verification>
Unlock password>
password is the LOCK password you choose. The password is a
string of 1 to 6 keyboard characters.
Normal Response:
Local -109- Port 3 locked
Error Response:
Local -741- Invalid password
Local -742- Password verification error
NOTE
Remember the LOCK password. You can unlock a terminal only
with the password or by logging it out from the supervisor port
terminal in privileged mode.
CHAPTER 5 MUXserver 100 COMMAND DESCRIPTIONS 29