Server Characteristics - Digital Equipment MUXserver 100 Reference Manual

Following setup, you can change the server characteristics from privilege mode.
Use the DEFINE SERVER command to modify the permanent characteristics.
These changes become operational when you initialize the server, or if the ap-
plicable user logs into the server. Use the SET SERVER command to modify
the operational characteristics. These changes become operational immediately,
but do not stay in effect after initialization or subsequent login by affected
user.
To set up the server characteristics, specify a value for each with the DEFINE
SERVER command. Chapter 5 contains the command description and the syn-
tax for DEFINE SERVER. Table 2··1 lists the server characteristics. Sections
2.4.1 through 2.4.3 describe the server characteristics.
Table 2-1 SE~rver Characteristics
Characteristic
CIRCUIT TIMER
DUMP
HEARTBEAT
KEEPALIVE TIMER
IDENTIFICATION
LOGIN LIMIT
NAME
NUMBER
SOFTWARE
Function
specifies the interval between server messages on
the Ethernet, in milliseconds.
deterrnines whether up-line dumping occurs.
enables or disables collision detect circuitry,
checkllng.
speciflles the interval between server messages
when no data is transmitted.
designates the identification of the server.
limits the number of login attempts.
assigns a server name.
specifies a server number.
specifies the file name of the MUXserver 100
software load image.
CHAPTER 2 SETTING UP THE MUXserver 100 AND ITS TERMINALS 9