Status (Part Of The Communications Sub-Directory); Start Test - Digital Equipment MUXserver 100 Reference Manual

5.38 STATUS (Part of the Communications Sub-
directory)
This command is executed from the privileged communications
sub-~irectory
(that is, in response to the COM> prompt) and shows the counters for the
composite Ports A and B.
For a description of the counter see the SHOW COMMUNICATIONS
command.
Syntax:
STATUS
Example:
COM>
STATUS
DSRZA Statistics (Firmware Version x.x)
TOTAL DATA TOTAL CRC TOTAL DATA TOTAL XMIT
LINK FRAMESFRAMESREC'O REC'O OSRCTS &FRAMESFRAMESXMIT TIME-
REC'O REC'O ERRORSERRORS CD XMIT XMrT ERRORSOUTS
Port A 2619 2523 0
Port B 1233 1145 8
5.39 START TEST
o
7
ON ON
ON ON
2326 2215 0
1244 1236 0
Use this command as a tool to test a port's operation.
4
2
The command generates a continuous stream of ASCII characters which are
transmitted directly to a device attached to a server port.
If
you enter only the keywords START TEST and a port number, the server
sends a continuous stream of characters to the port device. This continues until
you press any key at that device. You also stop the test when you specify the
port in the STOP TEST command.
Syntax:
START TEST [PORT number] [WIDTH number] [COUNT number]
62 CHAPTER 5 MUXserver 100 COMMAND DESCRIPTIONS