Disconnect (Part Of The Communications Sub-Directory); Forwards - Digital Equipment MUXserver 100 Reference Manual

5.9 DISCONNECT (Part of the Communications Sub-
directory)
NOTE
A separate DISCONNECT comrnand exists to terminate a session
on an Ethernet mode. See Section 5.8, DISCONNECT.
Use this command to terminate access to the supervisor port of a remote
DECmux II unit (see the CONNECT command for information on accessing a
remote DECmux II unit).
An error message is given if you are not connected to a remote DECmux II
unit.
A CONTROL-C character or EXIT will also disconnect you from a remote
DECmux II unit.
Syntax:
AI> DISCONNECT
Example:
A1> DISCONNECT
COM>
Error Response:
You are not connected anywhere.
5.10 FORWARDS
Use this command to resume the next session.
The next session is the second session in the SHOW SESSIONS display list.
If
you have only one active session, that session resumes, and message 102
appears. If you have two active sessions, your non-current session resumes.
Syntax:
FORWARDS
Example:
Local> FOR
CHAPTER 5 MUXs;erver 100 COMMAND DESCRIPTIONS 25