Maphelp (Part Of The Communications Sub-Directory) - Digital Equipment MUXserver 100 Reference Manual

NOTE
To make a changed map permanent, the SAVE command must be
performed. To implement these changes, a RESTART or
INITIALIZE is required on the MUXserver 100.
Example: (see Figure 2-1 for multiplexer configuration)
COM> MAP
Multiplexer port map
Mux. : B2-up
Port: 0 1 2 3 4 5 6 7
Conn: ABC D E F G H
Self-Master-up
234 5 6 7 8 9
C D E F G H
11111111
o
1 234 567
K L M N 0 P
A1-down
o
1 234 567
A B K L M N 0 P
In this example, Port 0 of DECmux B2 is shown logically connected to Port 0
of DECmux AI. Similarly, Port 1 of B2 is mapped to Port 1 of AI. Because of
these connections, Ports 2, 3, 10 and 11 of the MUXserver 100 are not used.
NOTE
The system generates its own link numbering scheme based on the
information entered prior to the execution of CTRL/Z. If the MAP
function is re·entered, the characters used to identify the links may
differ from those previously entered, but a check will show they
represent the same links.
5.17 MAPHELP (Part of the Communications Sub-
directory)
This command is privileged and is executed in the communications sub-
directory (in response to the COM> prompt). It provides help information on
the use of the MAP command.
Syntax:
MAPHELP
34 CHAPTER 5 MUXserver 100 COMMAND DESCRIPTIONS