Disconnect Command; Exit Command - Digital Equipment MUXserver 100 Reference Manual

6.3.3 DISCONNECT Command
The DISCONNECT command returns control of a remote multiplexer to its
local supervisor port, and reconnects the CONNECTed supervisor port to con-
trolling its own operations and parameters. This command has no nleaning if
the operator has not previously completed a CONNECT command successfully
and will indicate such with a suitable error message.
Syntax:
DISCONNECT
Example:
A1> DIS
SYS>
6.3.4 EXIT Command
The EXIT command logs out the operator from supervisor control.
To re-enter the supervisor control, the operator must log on as described in
Section 6.3, DECmux II COMMAND PROCESSOR SUMMARY.
Syntax:
EXIT
Example:
SYS> EX
8 CHAPTER 6 DECmux II OPERATION