Table of Contents
Advertisement
3.1.4.2
Using MUXserver 100 Commands on a Remote Console -
The
MUXserver 100 pound sign
(#)
prompt appears when you successfully connect
the remote console through any node (regardless of the node's operating
system).
You first enter the MUXserver 100 login password. (The terminal characteristic
LOGIN is always enabled for the remlote console).
If
it has not been changed,
the password is "access". Following successful login, the user name prompt
(Enter user-name» appears, and you are in local mode on the MUXserver 100.
The remote console is not physically connected to a terminal port on the
MUXserver 100 unit. This affects SOIne of the MUXserver 100 commands that
you can enter.
You can issue any MUXserver 100 command at the remote console except for
the following:
DEFINE PORT for the remote console
SET PORT for the remote console
SHOW PORT for the remote console
You can, however, issue these three commands for any of the "regular" ports.
Information about the remote console does not appear for the following com-
mands typed at any terminal:
SHOW SESSIONS ALL
SHOW TERMINAL ALL
SHOW USERS
The terminal characteristics for the remote console are fixed and defined as
follows:
ACCESS LOCAL
AUTHORIZED GROUPS ALL ENABLED
AUTO BAUD DISABLED
AUTOCONNECT DISABLED
AUTOPROMPT ENABLED
BACKWARD SWITCH NONE
BROADCAST DISABLED
DEDICATED SERVICE NONg
FLOW CONTROL DISABLED
FORWARD SWITCH NONE
LOCAL SWITCH -
LOSS NOTIFICATION ENABLED
MESSAGE CODES ENABLED
CHA.PTER 3 MANAGING AND MONITORING
7
Advertisement
Table of Contents
