Terminal Behavior And Possible Problems - Digital Equipment MUXserver 100 Reference Manual

Problem 3 There is a loose or faulty terminal cable.
Correction: Be sure the terminal cable is secure at both the termi-
nal server and the terminal. If the cable is made of several sec-
tions, be sure all junctions are secure. Inspect the cable for any
cuts or crimps. If the cable is not loose or damaged, try another
terminal cable.
NOTE
Check with Section 1.10 of the }JUXserver 100 Network
I nstallation Manual for the correct cable, pin assignments and
maxhnum cable lengths.
Table 4-1 Terminal Behavior and Possible Problems
Behavior Problem
Problem
Number
No display No power to terminal
1
and
nonresponsive
Faulty terminal 2
Loose or faulty terminal cable 3
Terminal speed set incorrectly
4
Terminal parity or character size
set incorrectly
5
Terminal failing- to autobaud
6
Dedicated service not available
7
Faulty terminal port on server
9
Not all Flow control disabled
8
characters
displayed Terminal parity or character size
set incorrectly 5
CHAPTER 4 MUXserver 100 TROUBLESHOOTING 29