Table of Contents
Advertisement
MESSAGE CODES
Each MUXserver
100
message has a luessage code. For example, in the follow-
ing error message, the number
701
is the message code.
LOCAL - 701 - Command syntax error
If
you define MESSAGE CODES as DISABLED, the message code does not
appear. The default is ENABLED.
VERIFICATION
Verification messages are informational notes sent to the terminal when the
user initiates, terminates, or switches sessions.
If
a lot of switching is done,
you can enter DISABLED for VERIF1[CATION, and these informational mes-
sages do not appear. This does not affect the receipt of warning and error mes-
sages. The default for VERIFICATION is ENABLED.
2.8 MUXserver 100 INITIALIZATION
You can initialize the MUXserver
100
in one of three ways:
1.
By electrical power-up.
2.
By entering the
INITIALIZE~
command.
3.
By entering RESTART in
re~sponse
to the COM> prompt. See
Section 2.5, SETTING UP THE COMPOSITE LINK
PARAMETERS.
The following sequence occurs at initialization. When you enter the
INITIALIZE command, the sequence begins at Step
1.
When you enter
RESTART, the sequence begins at St.ep 2. When you power-up the server, the
sequence begins at Step 3.
1.
The MUXserver
100
sends warning messages to users at regular in-
tervals. These indicate that initialization is about to begin.
2.
The server disconnects all active ports from network services.
3.
The server diagnostic self-test executes (refer to Chapter 4, Section
4.1,
WHAT TO DO FIRST).
CHAPTER 2 SETTING UP THE MUXserver 100 AND ITS TERMINALS
35
Advertisement
Table of Contents
