Table of Contents
Advertisement
MUXserver 100
SUPERVISOR
DECmux
/I
(A 1 )
CONNECTS TO B PORT
DECmux
/I
(A2)
CONNECTS TO B PORT
CS-5363
Figure 2-2 Numbering System for the Second Default Multiplexer Configuration
NOTE
The numbering system for the 'CONNECT' command is relative to
the unit executing the command. For example if you are 'connect-
ing' to the MUXserver 100 froml a remote DECmux II unit, the
numbering scheme is relevant to that DECmux unit.
To identify the numbering system which applies from any supervi-
sor port, first type the MAP cOlnmand whose display includes this
inforlnation. See Section 2.6,
SE~TTING
UP THE NETWORK
MAP.
CHAPTER 2 SETTING UP THE MUXserver 100 AND ITS TERMINALS
7
Advertisement
Table of Contents
