Halt Command; Test Command - Digital Equipment MUXserver 100 Reference Manual

6.3.15 HALT Command
To suspend execution of a command, type CONTROL-C (I"C). This is the
HALT command. This character is generated by holding down the CONTROL
and C keys simultaneously.
6.3.16 TEST Command
The TEST command is used to put the DECmux II unit into Test mode. This
will suspend normal operation, and for this reason, the operator is warned of
this effect and asked to verify the operation, as shown below.
When maintenance mode is successfully entered, the test menu will be dis-
played. (The eight off-line tests are described in Chapter 7, Sections 7.2.2.1
through 7.2.2.8.)
To select a test, enter the number of the test from the menu when prompted
to do so.
To restart the system, type < RETURN> at the Test Menu. This will cause
the multiplexer to reinitialize.
Syntax:
TEST
CHAPTER 6 OECmux II OPERATION 23