Connect - Digital Equipment MUXserver 100 Reference Manual

Syntax:
COMMUNICATIONS
Example:
LOCAL> COMM
COM> (now enter sub-directory commands)
COM> EXIT
LOCAL>
Error Response:
Remote MUXserver 100 connected.
This message indicates that a conneetion already exists from a remote
DECmux II supervisor port into the supervisor port of the MUXserver 100.
Only after this connection has been disconnected (use the DISCONNECT com-
mand at the remote DECmux II unit) can the 'COMM' command be executed.
5.4 CONNECT
NOTE
A separate 'CONNECT' command also exists in the communica-
tions subdirectory. See Section 5.5.
Use this command to establish a session with a service. Once the connection is
established, you remain in service mode until you enter the local switch charac-
ter, until the service terminates the connection, or until you log out from the
service. If a service terminates a session, the server notifies you and returns
your terminal to local mode. If the sBrvice you request is not available, you
receive a message informing you of this, and the terminal remains in local
mode.
If you enter only the keyword CONNECT, the MUXserver 100 connects you to
a preferred service, if one is specified.
If terminal n is a non-keyboard device (for example, a printer), you can type
CONNECT PORT n to connect it.
CHAPTER 5 MUXserver 100 COMMAND DESCRIPTIONS 5