Table of Contents
Advertisement
6.3 DECmux II COMMAND PROCESSOR SUMMARY
The DECmux II command processor enables operational parameters of the
DECmux II unit and multiplexer network to be controlled and monitored by
means of the supervisor terminal.
The command processor commands are detailed in Sections 6.3.1 through
6.3.16. To enter the command processor, perform the following:
•
Type carriage return.
•
Following the PASSWORD> prompt, type in your password.
•
The default password is SYSTEM.
•
Following the SYS> prompt type the required command.
If
you are a
new user, try HELP first.
The SYS> prompt specifies that the command processor is active.
If
you
change a DECmux II parameter and wish to save the new value, be sure to use
the SAVE command. Refer to Section 6.3.11 for SAVE command operation.
NOTE
After you have finished with the command processor, be sure to log
out. Failure to log out will inhibit remote access to your DEClnux
II unit by means of the CONNECT command.
To log out of the command processor, type EXIT following the SYS> prompt.
6.3.1 CONNECT Command
This command allows the supervisor of a DECmux II unit to log on as supervi-
sor to the MUXserver 100 or other DECmux II unit in the network, and per-
form system control and supervisor commands as specified in Section 6.2.3.1,
Remote Supervisor Commands.
Syntax:
CONNECTXn
Parameters:
Xn - Is the remote multiplexer to connect to, and can be anyone of the follow-
ing, depending on the network configuration:
A3, A2, AI, B1, B2, B3
6
CHAPTER 6 OECmux II OPERATION
Advertisement
Table of Contents
