Define Set - Server - Digital Equipment MUXserver 100 Reference Manual

VERIFICATION
Examples:
specifies whether the server sends informational
messages when you connect, disconnect, or switch
sessions. DISABLED inhibits informational mes-
sages; ENABLED permits display of the messages.
This comntland does not affect error and warning
messages. The default is ENABLED.
Local> DEF POR 2 ACCESS DYNAMIC INTERRUPT ENA
Local> SET POR 8 AUTH 1,2,6-19, 25 ENA SES LIM 3
Local> DEF AUTOC ENA PRE DEVELOP
The first example defines access for port 2 as either local or remote, and en-
ables the port user to interrupt a reIJ[lote session. The options in the second
example affect how port eight can be used in service mode, and are in effect
only until the port is logged out. In the third example, a preferred service is
permanently assigned to the port.
5.7 {DEFINE} SERVER
{SET}
Use these commands to specify MUXserver 100 characteristics. These are
privileged commands.
The DEFINE command alters the server's permanent database and the
changes do not take effect until the next initialization procedure. The SET
command alters the server's operational database. These changes take effect
immediately but do not remain in effect after an initialization.
CHAPTER 5
MUX~:;erver
100 COMMAND DESCRIPTIONS 17