Duress Code - Honeywell GX-Series Installation And Setup Manual

GX-Series Control Panel Installation and Setup Guide
Level
1.0† Guard
2.1† Cleaner
2.2† Caretaker
2.3 Users
2.4 Users
2.5 Users
3.6‡ Manager
3.7‡ Engineer
3.8‡ Remote
† No access to menu functions
‡ The manager, engineer and remote codes (the last three codes on the system) have fixed types which cannot be
reprogrammed.
NOTE: All levels except guard can change their own PIN.

Duress Code

If the # key is pressed while the Modify Level option is accessed, then the current user code is assigned
as a Duress Code. Entry of a Duress Code at any time activates any output programmed as Duress
(refer to option 53 = OUTPUTS). There is no limit to the number of codes that can be assigned as
Duress Codes. Entry of any valid user code followed by ## is also a duress code.
Quick Menu
All of the user codes default to the quick menu. This menu is made up of a selection of ten options (0 – 9)
from the full menu options 11 – 68. Access to the quick menu is controlled by the user type. Any user can
be upgraded from the quick menu to the full menu by assigning a * to the user while the Modify Type
option is accessed. Therefore a user with type * 2.5 would have access to the full menu from options 11 –
42. No code can access both menus.
The engineer can reprogram the options contained in the quick menu (refer to option 59 = QUICK
MENU).
NOTE: The master manager code defaults to the full menu.
The engineer can determine the menu option access type (refer to option 68 = MENU ACCESS); this
allows users to access menu options that their code types are not, by default, authorized to access.
3 = Modify Name
This option allows a name to be assigned to the user (maximum 6 characters). Each of the user codes
default to the name USER. The engineer (ENG) and manager (MGR) are fixed and cannot be
reprogrammed. On selecting the Modify Name option, a section of the alpha-numeric characters that
can be assigned to the user name is displayed on the bottom line of the keypad; the cursor flashes on the
letter L. Press the * key to erase the characters of the default or previous name. When the previous
name has been erased, use the A> or <B keys to move the cursor to the first character of the name and
press the ent key; the selected character appears on the top line. Continue this process until the name is
completed.
The # key moves between upper and lower case characters and the system library. The alpha-numeric
characters and library words can be selected by entering the character or word reference number (refer
to Appendix A — Library) or by pressing the A> or <B keys.
When the user name is completed, press the esc key to accept the programming and return to the
previous menu level.
Entered into event memory – no other option
Can only set (arm) the system and change own PIN
Can only set (arm) and unset (disarm) the system and change own PIN
Menu options 11 - 19
Menu options 11 - 25
Menu options 11 - 32
Menu options 11 - 48
Menu options 11 - 71
Menu options 11 - 71
Table 6-6. User Access Levels
6-24
Access Availability