Appendix C: Sia Event Structure - Honeywell GX-Series Installation And Setup Manual

Appendix C: SIA Event Structure

Event SIA ACC.
Type LEVEL Block
ZONE 3,4 #xxxxx
2 #xxxxxx
1 #xxxxxx
0 #xxxx
User 3,4 #xxxxxx
2 #xxxxxx
1 #xxxxxx
0 #xxxx
Module 3,4 #xxxxxx
2 #xxxxxx
1 #xxxxxx
0 #xxxx
Event 3,4 #xxxxxx
2 #xxxxxx
1 #xxxxxx
0 #xxxx
Key:
Data Block
ti Time modifier
ri Group modifier (not used if groups are disabled)
id User modifier
u User number
pi Peipheral modifier
m Peripheral number
EV Event Code Type (see SIA event list supplied)
z Zone number
x maximum digits for modifier field
GX-Series Control Panel Installation and Setup Guide
DATA Block Format (N
block code)
Ntixx:xx/rixx/EVzzzz
Ntixx:xx/rixx/EVzzzz
NEVzzzz
NEVzzzz
Ntixx:xx/rixx/iduuu/pixxx/EV
Ntixx:xx/rixx/iduuu/pixxx/EV
NEVmmm
NEVmmm
Ntixx:xx/rixx/pimmm/EV
Ntixx:xx/rixx/pimmm/EV
NEVmmm
NEVmmm
Ntixx:xx/rixx/EV
Ntixx:xx/rixx/EV
NEV
NEV000
Ascii Block
e Log event (9 chars, see GX Log Event in table supplied)
s Event state ('+' : ON, '-' : OFF, ' ' : NOT USED)
i Site identifier (8 char description of site - can be blank)
d Descriptor (additional text to describe event),
Ascii Block Format Explanation
(A block code)
Aeeeeeeeeesiiiiiiii Detector alarmed, keyswitch etc
dddddddddddddddd
Aeeeeeeeeesiiiiiiii User Set/Unset, reset, duress, etc
dddddd
Aeeeeeeeeesiiiiiiii 1. With ri modifier: Set with A or B key
ddd without code
2. 2. Without ri modifier: Keypad
added, Rio missing etc
Aeeeeeeeeesiiiiiiii 1. With ri modifier: Automatic set,
timer activated
2. 2. Without ri modifier: Automatic
test, engineer mode
1. Zone Event - 16 char zone descriptor
2. User Event - 6 char user name
3. Module Event - 3 char module name,
'RIO' (8 zone module), 'KEY' (keypad), 'MAX' (Proximity
Reader 'COM' (COM1 = Int Telecom, COM4 = Ethernet,
COM6 = Int RS232)
C-1